Summary:
WriteController had a number of issues:
* It could introduce a delay of 1ms even if the write rate never exceeded the
configured delayed_write_rate.
* The DB-wide delayed_write_rate could be exceeded in a number of ways
with multiple column families:
* Wiping all pending delay "debts" when another column family joins
the delay with GetDelayToken().
* Resetting last_refill_time_ to (now + sleep amount) means each
column family can write with delayed_write_rate for large writes.
* Updating bytes_left_ for a partial refill without updating
last_refill_time_ would essentially give out random bonuses,
especially to medium-sized writes.
Now the code is much simpler, with these issues fixed. See comments in
the new code and new (replacement) tests.
Pull Request resolved: https://github.com/facebook/rocksdb/pull/8064
Test Plan: new tests, better than old tests
Reviewed By: mrambacher
Differential Revision: D27064936
Pulled By: pdillinger
fbshipit-source-id: 497c23fe6819340b8f3d440bd634d8a2bc47323f
Summary:
For performance purposes, the lower level routines were changed to use a SystemClock* instead of a std::shared_ptr<SystemClock>. The shared ptr has some performance degradation on certain hardware classes.
For most of the system, there is no risk of the pointer being deleted/invalid because the shared_ptr will be stored elsewhere. For example, the ImmutableDBOptions stores the Env which has a std::shared_ptr<SystemClock> in it. The SystemClock* within the ImmutableDBOptions is essentially a "short cut" to gain access to this constant resource.
There were a few classes (PeriodicWorkScheduler?) where the "short cut" property did not hold. In those cases, the shared pointer was preserved.
Using db_bench readrandom perf_level=3 on my EC2 box, this change performed as well or better than 6.17:
6.17: readrandom : 28.046 micros/op 854902 ops/sec; 61.3 MB/s (355999 of 355999 found)
6.18: readrandom : 32.615 micros/op 735306 ops/sec; 52.7 MB/s (290999 of 290999 found)
PR: readrandom : 27.500 micros/op 871909 ops/sec; 62.5 MB/s (367999 of 367999 found)
(Note that the times for 6.18 are prior to revert of the SystemClock).
Pull Request resolved: https://github.com/facebook/rocksdb/pull/8033
Reviewed By: pdillinger
Differential Revision: D27014563
Pulled By: mrambacher
fbshipit-source-id: ad0459eba03182e454391b5926bf5cdd45657b67
Summary:
Introduces and uses a SystemClock class to RocksDB. This class contains the time-related functions of an Env and these functions can be redirected from the Env to the SystemClock.
Many of the places that used an Env (Timer, PerfStepTimer, RepeatableThread, RateLimiter, WriteController) for time-related functions have been changed to use SystemClock instead. There are likely more places that can be changed, but this is a start to show what can/should be done. Over time it would be nice to migrate most (if not all) of the uses of the time functions from the Env to the SystemClock.
There are several Env classes that implement these functions. Most of these have not been converted yet to SystemClock implementations; that will come in a subsequent PR. It would be good to unify many of the Mock Timer implementations, so that they behave similarly and be tested similarly (some override Sleep, some use a MockSleep, etc).
Additionally, this change will allow new methods to be introduced to the SystemClock (like https://github.com/facebook/rocksdb/issues/7101 WaitFor) in a consistent manner across a smaller number of classes.
Pull Request resolved: https://github.com/facebook/rocksdb/pull/7858
Reviewed By: pdillinger
Differential Revision: D26006406
Pulled By: mrambacher
fbshipit-source-id: ed10a8abbdab7ff2e23d69d85bd25b3e7e899e90
Summary:
When dynamically linking two binaries together, different builds of RocksDB from two sources might cause errors. To provide a tool for user to solve the problem, the RocksDB namespace is changed to a flag which can be overridden in build time.
Pull Request resolved: https://github.com/facebook/rocksdb/pull/6433
Test Plan: Build release, all and jtest. Try to build with ROCKSDB_NAMESPACE with another flag.
Differential Revision: D19977691
fbshipit-source-id: aa7f2d0972e1c31d75339ac48478f34f6cfcfb3e
Summary:
If ReadOptions.low_pri=true and compaction is behind, the write will either return immediate or be slowed down based on ReadOptions.no_slowdown.
Closes https://github.com/facebook/rocksdb/pull/2369
Differential Revision: D5127619
Pulled By: siying
fbshipit-source-id: d30e1cff515890af0eff32dfb869d2e4c9545eb0
Summary:
Add two DB properties: rocksdb.actual_delayed_write_rate and rocksdb.is_write_stooped, for people to know whether current writes are being throttled.
Closes https://github.com/facebook/rocksdb/pull/2043
Differential Revision: D4782975
Pulled By: siying
fbshipit-source-id: 6b2f5cf
Summary:
NowMicros() provides non-monotonic time. When wall clock is
synchronized or changed, the non-monotonicity time points will affect write rate
controllers. This patch changes write_controller.cc and rate_limiter.cc to use
monotonic time points.
Closes https://github.com/facebook/rocksdb/pull/1865
Differential Revision: D4561732
Pulled By: siying
fbshipit-source-id: 95ece62
Summary:
Current write stalling system has the problem of lacking of positive feedback if the restricted rate is already too low. Users sometimes stack in very low slowdown value. With the diff, we add a positive feedback (increasing the slowdown value) if we recover from slowdown state back to normal. To avoid the positive feedback to keep the slowdown value to be to high, we add issue a negative feedback every time we are close to the stop condition. Experiments show it is easier to reach a relative balance than before.
Also increase level0_stop_writes_trigger default from 24 to 32. Since level0_slowdown_writes_trigger default is 20, stop trigger 24 only gives four files as the buffer time to slowdown writes. In order to avoid stop in four files while 20 files have been accumulated, the slowdown value must be very low, which is amost the same as stop. It also doesn't give enough time for the slowdown value to converge. Increase it to 32 will smooth out the system.
Closes https://github.com/facebook/rocksdb/pull/1562
Differential Revision: D4218519
Pulled By: siying
fbshipit-source-id: 95e4088
Summary:
If options.base_background_compactions is given, we try to schedule number of compactions not existing this number, only when L0 files increase to certain number, or pending compaction bytes more than certain threshold, we schedule compactions based on options.max_background_compactions.
The watermarks are calculated based on slowdown thresholds.
Test Plan:
Add new test cases in column_family_test.
Adding more unit tests.
Reviewers: IslamAbdelRahman, yhchiang, kradhakrishnan, rven, anthony
Reviewed By: anthony
Subscribers: leveldb, dhruba, yoshinorim
Differential Revision: https://reviews.facebook.net/D53409
Summary: It's usually hard for users to set a value of options.delayed_write_rate. With this diff, after slowdown condition triggers, we greedily reduce write rate if estimated pending compaction bytes increase. If estimated compaction pending bytes drop, we increase the write rate.
Test Plan:
Add a unit test
Test with db_bench setting:
TEST_TMPDIR=/dev/shm/ ./db_bench --benchmarks=fillrandom -num=10000000 --soft_pending_compaction_bytes_limit=1000000000 --hard_pending_compaction_bytes_limit=3000000000 --delayed_write_rate=100000000
and make sure without the commit, write stop will happen, but with the commit, it will not happen.
Reviewers: igor, anthony, rven, yhchiang, kradhakrishnan, IslamAbdelRahman
Reviewed By: IslamAbdelRahman
Subscribers: leveldb, dhruba
Differential Revision: https://reviews.facebook.net/D52131
Summary:
We slow down data into the database to the rate of options.delayed_write_rate (a new option) with this patch.
The thread synchronization approach I take is to still synchronize write controller by DB mutex and GetDelay() is inside DB mutex. Try to minimize the frequency of getting time in GetDelay(). I verified it through db_bench and it seems to work
hard_rate_limit is deprecated.
options.delayed_write_rate is still not dynamically changeable. Need to work on it as a follow-up.
Test Plan: Add new unit tests in db_test
Reviewers: yhchiang, rven, kradhakrishnan, anthony, MarkCallaghan, igor
Reviewed By: igor
Subscribers: ikabiljo, leveldb, dhruba
Differential Revision: https://reviews.facebook.net/D36351
Summary:
Introducing WriteController, which is a source of truth about per-DB write delays. Let's define an DB epoch as a period where there are no flushes and compactions (i.e. new epoch is started when flush or compaction finishes). Each epoch can either:
* proceed with all writes without delay
* delay all writes by fixed time
* stop all writes
The three modes are recomputed at each epoch change (flush, compaction), rather than on every write (which is currently the case).
When we have a lot of column families, our current pull behavior adds a big overhead, since we need to loop over every column family for every write. With new push model, overhead on Write code-path is minimal.
This is just the start. Next step is to also take care of stalls introduced by slow memtable flushes. The final goal is to eliminate function MakeRoomForWrite(), which currently needs to be called for every column family by every write.
Test Plan: make check for now. I'll add some unit tests later. Also, perf test.
Reviewers: dhruba, yhchiang, MarkCallaghan, sdong, ljin
Reviewed By: ljin
Subscribers: leveldb
Differential Revision: https://reviews.facebook.net/D22791
Peter Dillinger